Home Contact Sitemap

AFGROW | DTD Handbook

Handbook for Damage Tolerant Design

  • DTDHandbook
    • About
    • Contact
    • Contributors
    • PDF Versions
    • Related Links
    • Sections
      • 1. Introduction
        • 0. Introduction
        • 1. Historical Perspective on Structural Integrity in the USAF
        • 2. Overview of MIL-HDBK-1530 ASIP Guidance
        • 3. Summary of Damage Tolerance Design Guidelines
          • 0. Summary of Damage Tolerance Design Guidelines
          • 1. Summary of Guidelines
          • 2. Design Category
          • 3. Inspection Categories and Inspection Intervals
          • 4. Initial Damage Assumptions
          • 5. Residual Strength Guidelines
          • 6. Required Periods Of Safe Damage Growth
          • 7. Illustrative Example Of Guidelines
            • 0. Illustrative Example Of Guidelines
            • 1. Slow Crack Growth Structure
            • 2. Fail Safe Structure
              • 0. Fail Safe Structure
              • 1. In-Service Inspection Consideration
              • 2. Initial Flaw Considerations
              • 3. In-Service Flaw Assumptions Following Inspection
              • 4. Adjacent Structure Damage Following the Failure of the Major Load Path
              • 5. Analysis of Intact Structure–Residual Strength Guidelines and Damage Growth Limits
              • 6. Analysis of Intact Structure (Alternate Requirement)
              • 7. Discussion of Intact Structure Analysis
              • 8. Analysis of Remaining Structure Subsequent to Load Path Failure
              • 9. Derivation of Residual Strength Load
              • 10. Incremental Damage Growth Da
              • 11. Alternative-Analysis of Remaining Structure Subsequent to Load Path Failure
              • 12. Summary and Comments
        • 4. Sustainment/Aging Aircraft
        • 5. References
      • 2. Fundamentals of Damage Tolerance
      • 3. Damage Size Characterizations
      • 4. Residual Strength
      • 5. Analysis Of Damage Growth
      • 6. Examples of Damage Tolerant Analyses
      • 7. Damage Tolerance Testing
      • 8. Force Management and Sustainment Engineering
      • 9. Structural Repairs
      • 10. Guidelines for Damage Tolerance Design and Fracture Control Planning
      • 11. Summary of Stress Intensity Factor Information
    • Examples
« Previous
Next »

Section 1.3.7.2.7. Discussion of Intact Structure Analysis

Although the structure in the example was assumed to be depot level inspectable for less than a failed load path, the intact structure requirement associated with this set of conditions might have been more difficult to meet than would be the case if the structure were not inspectable for less than a failed load path.  In the latter case, it would be satisfactory for the designer to qualify the structure under the alternate requirement described in Section 1.3.7.2.6.  As is often the case, the designer may choose to qualify the structure in the easiest (analysis) manner.


« Previous
Next »